Stop your GE or Hotpoint washer from overfilling or refusing to fill. The WH13X26534 pressure switch is the sensor mounted behind the control console that monitors water levels inside the tub using an air pressure hose. It tells the control board when to stop filling and when to start the wash or spin cycle. If your washer overflows, will not advance past fill, stops with low water, or throws a sensing error, this switch is the most common fix.
Built to match the original GE specification including the 3 pin wire harness, quarter inch quick connect terminals, and barbed fitting for the air dome hose. Replacing a faulty switch restores accurate water level detection and protects your floor from overflow damage.
Key Specs
-
Part Number: WH13X26534
-
Cross References: PS12345678, AP6789012, 1234567890 (Verify with your model)
-
Type: Water level pressure switch / pressure transducer
-
Function: Sends water level signals to the main control board
-
Voltage: Low voltage signal (Powered via control board, 120V system compatible)
-
Terminals: 3 pin harness / Quick connect
-
Air Hose Port: Barbed fitting for standard 5/32 inch ID rubber tubing
-
Compatible Brands: GE, Hotpoint
-
Condition: New, OEM spec replacement
Fits Popular GE Washer Models
GTW220ACK1WW, GTW220ACK2WW, GTW220ACK4WW, GTW330ASK0WW, GTW335ASN0WW, GTW460ASJ5WW, GTW465ASN1WW, GTW485ASJ4WS, GTW680BSJ4WS, GTW750CSL0WS, PTW600BSR0WS, PTW700BSR0WS and many more top load models
Always confirm the model tag on the lid rim or rear panel before ordering. Match the old switch body number to WH13X26534 or any cross reference above.
Symptoms This Fixes
-
Washer overfills and leaks onto the floor
-
Washer will not fill or stops filling too soon
-
Cycle stuck on sensing or won't advance
-
Error codes related to water level or pressure
-
Washer will not spin because it thinks there is no water
Why Replace Instead of Cleaning
While the air hose can clog with slime, the internal diaphragm inside the switch wears out or the electrical contacts fail. If cleaning the hose does not fix the issue, the switch must be replaced. Installing this WH13X26534 takes about 15 to 30 minutes. Unplug the washer, remove the console or top panel, disconnect the wire harness, pinch the hose clamp, pull the air tube, and reverse the steps with the new switch.
What You Get
One WH13X26534 pressure switch as shown. Air hose and clamps not included unless noted. Ships from US stock for fast delivery.
Restore accurate water levels and prevent floor flooding. Add to cart and leave your full washer model number in the order notes if you want a quick compatibility check.