Get your Samsung electric dryer heating again with this direct-fit DC47-00032A heating element. Built to match OEM specs, this 3-terminal coil unit sits inside the DC93-00154A heater housing and restores full drying performance when your dryer runs but produces no heat or low heat.
What It Is
-
Part Number: DC47-00032A (cross-references DC93-00154A, AP5582094, 3282568, PS4216214, EAP4216214, PD00002235)
-
Type: Clothes dryer heating element, 3-wire terminal, 8-coil design
-
Voltage and Wattage: 240V, 3700W plus 1500W dual-rated
-
Dimensions: Approx 9 7/8 inches L x 6 1/2 inches W x 2 1/8 inches H
-
Material: Nickel-chromium resistance wire with ceramic insulator supports, metal mount frame
-
Condition: New aftermarket replacement, not original Samsung boxed part
Compatible With Samsung Dryers
Fits many Samsung front-load electric dryer models including but not limited to:
-
DV42H5600EP/A3, DV42H5600EW/A3
-
DV45H6300EG/A3, DV45H6300EW/A3, DV45K6500EV/A3, DV45K6500EW/A3
-
DV48J7700EW/A2, DV48J7770EP/A2
-
DV50K7500EV/A3, DV50K8600EV/A3, DV50R8500W/A3
-
DVE45R6300C/A3, DVE45R6300V/A3, DVE50A8600V/A3, DVE52M8650V/A3
-
DVE54R7600C/A3, DVE55A7300E/A3, DVE60M9900V/A3
Also used in select Kenmore dryers built on Samsung platforms. Confirm your model tag before ordering.
Symptoms This Fixes
-
Dryer turns on but clothes stay damp or cold
-
Cycle finishes but no warm air
-
Error codes tied to heater open circuit
-
Visual break or burn spot on old coil
Why Buy This Version
-
Drop-in fit for DC93-00154A heater duct assembly, no rewiring redesign needed
-
Dual 3700W and 1500W rating matches original Samsung thermal profile
-
Coil wound on mica board with centered terminals for even heat spread
-
Cost-effective alternative to full heater canister assembly when only the element burned out
Install Note
This listing is for the heating element only, not the full canister, high-limit thermostat, or thermal fuse. If your dryer also tripped the fuse or thermostat, replace those together to avoid repeat failure. Always unplug the dryer and let it cool before opening the rear or front panel. Basic socket set and 20 minutes are enough for most DIYers.
Compatibility Reminder
Brand and model references are for identification only. This is an aftermarket part, not Samsung-branded, but engineered to the published DC47-00032A electrical and dimensional spec.